- About Dennb10
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Dennb10
New here
Member since Sep 28, 2020
10-19-2020
Community Record
4
Posts
0
Kudos
0
Solutions
10-19-2020
11:59 AM
I am getting the following error on 3 of my MR-45 APs....They are all plugged into the same Cisco 9300 switch.... Error: Device is not recommended to be used with PoE (802.3af) and performance cannot be guaranteed. Please connect AP to PoE+ (802.3at) power source. I have a lot of other APs just like this plugged in the 9300 and working very well. thank you
... View more
09-28-2020
10:22 AM
David.... Are there any restrictions on the upstream CPE / Firewall?...None You can do a packet capture from going to Network Wide > Packet capture...I will try that Another thing to check is the performance of the AP's (if you upgrade to MR27.5 - Meraki Health will show a performance tab) Mainly to verify if it is the AP or the Client that is restrictive. Upgraded to 27.5 but had to fall back to 26 because of an issue with vers.27 Thank you
... View more
09-28-2020
09:39 AM
Thank you David....Here is some info: Number of MR45's deployed at the site:20 Number of clients connected to each AP..very few Covid has us down to maybe 6 in a 200 person office Number of SSID's in use: 2 Upstream devices (Switch / CPE) Cisco 9300 switch WAN connectivity type and bandwidth....MPLS 400MB FW and Traffic Bandwidth set to unlimited Thank you
... View more
09-28-2020
08:53 AM
Just deployed MR 45s and users are getting low connectivity around 1MB...What can I do to adjust this?? Thank you Dennb10
... View more
