Meraki

lollomil98 · ‎Sep 24 2020

Hi guys, I have some news. Basically the issue is that some client (we tested one) connected in 5Ghz with 50Db power (Very high) were roaming every 30s from one AP to another. I tried to disable CLient balancing - no success I disabled 5Ghz on all AP and the client stopped this strange beahviour The network adapter driver are updated Is there something we can test to overcome to this issue and enable 5Ghz frequency ? Thank you, Lorenzo

lollomil98 · ‎Sep 10 2020

Hi Philip, - yes the SSID is in bridge mode - I'll check with the customer all the WIFI drivers - I'm quite sure because with ethernet nobody has problem, only when connecetd to WiFi especially on the first floor - For now the utilization is low/very low but I have to check when there is the issue Thank you very much Lorenzo

lollomil98 · ‎Sep 10 2020

Hi Guys, I've a two floor building with 3 MR18 one the first floor and 3 on the second Sometimes especially on the second floor there are issues with SKype4Business with vioce and video. All the clients are in 5Ghz in the signal strength is always above 30dB. I made a change increasing the minimum data rates to 12Mb to delete 802.11b The only real issue that I see is that under some APs there are always 10 to 17/18 clients connected and I assume that if most of them made a call in the same time there would be some issues for these tye of APs How many clients are recommended under a single MR18? Could be better to change MR18 to MR33 only for some Aps where tehre are more clients Thank you very much 🙂 Lorenzo

Meraki

Community

About lollomil98

lollomil98

Community Record

Re: Maximum Clients per AP MR18

Re: Maximum Clients per AP MR18

Maximum Clients per AP MR18