Meraki

Community

About red1

Re: Is this possible? If not what am I missing?

by in Switching
‎Aug 4 2020 10:41 AM
‎Aug 4 2020 10:41 AM
Yes, on the left side, connected to regular non routing switch on port 2.    Yes the switch is left as is usually since I control everything from Mx. So no special config on switches but I tried even as trunk port on the switch and still no luck. The left side works just fine.  ... View more

Re: Is this possible? If not what am I missing?

by in Switching
‎Aug 4 2020 8:59 AM
‎Aug 4 2020 8:59 AM
When I try to ping from 172.16.2.100 to 172.16.2.40, I get request timed out. By default on the right side, I get dhcp and it is 192.168.70.0/24. If I switch my ip to static and change my subnet to 172.16.2.0/24 then I can ping x.100 but not x.40. ... View more

Is this possible? If not what am I missing?

by in Switching
‎Aug 4 2020 5:43 AM
‎Aug 4 2020 5:43 AM
This is my design as is. Meraki is configured with Vlans. Vlan 1, vlan 2, vlan 3 and Port 4 which is set to vlan 1. The left side of the graph is one side of the building, the right side is completely different area of another building.   When I plug the Edgeswitch on port 4 (no special configuration, routing enabled and layer3), I want to have the exact same topology on the right side of the graph as the left side. Be able to have both 192.168.70.0/24 and 172.16.2.0/24 network extended and communicating. And I want to be able to pass traffic from 172.168.2.100 through Edgeswitch to port 4 on Meraki then to Port 2 (vlan2) on and then to 172.16.2.40.   If not then how can I make it work? Feel free to change the graph or make another recommendation. As long as I can keep the subnets the same on both left and right side. Does this make sense?     ... View more
© 2024 Cisco Systems, Inc.