cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
  • About Tim-Kr

Re: VPN-Status -> Site-to-Site peer goes offline

by in Security / SD-WAN
‎12-21-2020 11:36 PM
‎12-21-2020 11:36 PM
Hi, thank you for your answer.   At the beginning we had a lot of issues with the ISP because of IPv6 public IPs and its following NAT issue.   The variation of the ISPs and connection types are big. It is not always the same ISP. We had the issue at Telekom, Vodafone and some lokal ISPs also with different connection types like DSL, COAX(tv cable), hybrid(DSL and LTE combined) and FTTH.   All the MX have a public IP-Address.   Maybe I go along with the scripting part 🙂 ... View more

Re: VPN-Status -> Site-to-Site peer goes offline

by in Security / SD-WAN
‎12-18-2020 01:53 AM
‎12-18-2020 01:53 AM
The remote Z3's are still connected to the cloud -> status LED = solid white. From my perspective it's only the peer which is dropping at some point. I also thought after a cold restart of the device, the peer should re-registered. Maybe the time between disconneting and plugin back the PSU ist to short.   At that point I did not open a case with the meraki support.  ... View more

VPN-Status -> Site-to-Site peer goes offline

by in Security / SD-WAN
‎12-17-2020 11:06 PM
‎12-17-2020 11:06 PM
Hello everybody, we operate a large teleworker network. We have two MX250 running warm spare mode and over 400 Z3 & MX64w are running as teleworkers. They running fimware version 14.53. This is the latest stable version available. For about two weeks we have had individual teleworkers losing their site-to-site peer. This always happens overnight / in the morning. To solve the problem we have to restart the teleworkers. Only a restart via the cloud helps (Tools -> Reboot appliance). Manually pulling out and plugging in the power supply does not bring any improvement. There are around three - five devices that are affected every day. They are not always the same either. Does anyone know what the cause of this could be?   Regards Tim ... View more

Re: MX 64 Unable to fetch configuration

by in Security / SD-WAN
‎06-29-2020 02:12 AM
‎06-29-2020 02:12 AM
Hi, I also have the issues "Unable to fetch configuration". We have multiple M64w running as Teleworker appliance. The issue appears randomly. An exchange device works perfectly fine at the same ISP. Only remove the device from network an add the new one.   In my cases I let the device sit. After a couple of hours the device get its config and starts working fine. Since now I had 5 devices with this problem.   Whenever I contact Meraki Support and they reply, the problem is solved. ... View more
© 2023 Meraki