Meraki

community_name · ‎Jun 26 2020

That's actually what I was thinking. But it's still strange to me that the first hop outside is a non-routable address.

community_name · ‎Jun 25 2020

Hello, Sorry, I should have been more specific. I am trying to ping the outside interface from a host on the internet, not from the LAN. The IP address 192.168.0.1 is not configured on any interface on the router. Those have all been configured with 10.x.x.x/8 addresses, so I'm not sure where it's getting the 192.168.0.1 address from. Also, 192.168.0.1 shows up in the arp table with the same MAC address as the external gateway IP. I've no particular need to load balance, but if it will fix the issue I can look into it. But I want to understand why this device is working (or failing to work) the way it is. Thanks

community_name · ‎Jun 25 2020

I have an MX-100 with two WAN circuits. One is "Active" and the other is "Ready". I can ping the active interface IP. I cannot get ping replies on the ready interface. If I start a ping and run a packet capture on the ready interface, I can see packets arriving and replies leaving, but the replies never make it back to the host of origin. If I run a traceroute back from the ready interface, the first hop is 192.168.0.1 . This network hasn't been configured anywhere on the device. Can anyone tell me what's going on? Is this normal for a backup interface?

Meraki

Community

About community_name

community_name

Community Record

Re: Cannot ping backup interface

Re: Cannot ping backup interface

Cannot ping backup interface