About Arpit-Patel

Arpit-Patel · ‎06-19-2020

Thanks Guys, I got it what you means to say and I understood where I was wrong. I think @jdsilva is right and I have to think of that. Also I referred the document that is being sent by @nealgs. I understood the concept and I cannot port-forward single to multiple LAN IPs. I cleared all my doubts now and will help to resolve my pain. I appreciate the help given by you guys.

Arpit-Patel · ‎06-19-2020

Hi Nealgs, Yes I am looking at that. But I found that I can divert the traffic for single port to multiple servers using 1 to many NAT.

Arpit-Patel · ‎06-19-2020

I am trying to make an inbound rule using port forwarding in the MX100 SD-WAN portal. But when I add a rule for allowing traffic on let's say port 80 (HTTP Incoming) it is allowing me to add only one LAN IP(Private) address whereas my 5 servers are listening to that port for different services. I want to add all of them, I tried but it is not accepting multiple private IPs (LAN IP) nor I can create a new rule with the same port number. Is it possible anyway to do that. As my old Watchgaurd firewall has that rule created and working fine. Any help would be appreciated.

Arpit-Patel

Community Record

Re: Assign Multiple LAN IP Ranges or Addresses for particular port

Re: Assign Multiple LAN IP Ranges or Addresses for particular port

Assign Multiple LAN IP Ranges or Addresses for particular port

Re: Assign Multiple LAN IP Ranges or Addresses for particular port