Meraki

MarkE · ‎Mar 25 2020

I remember seeing a short black patch cable although I don't remember if its flat. I'll be sure to check that out.

MarkE · ‎Mar 25 2020

Thanks CMR. Funny you should mention that. Last time I looked at the switch, I saw two devices running at 100. Now I only see one. Its a school that is closed based on the current situation so I can't see the switch but one device that was previously report 100 is now 1000. 🙄

MarkE · ‎Mar 25 2020

Thanks for the quick replies. This AP is on the same unmanaged gbit switch. There is only one switch. I'll check the max speed on the injector but I'm sure it runs at gbit. I have three other APs all using injectors and running at gbit. I'lll check the cabling (groan). All devices are running on the default indoor RF profile.

MarkE · ‎Mar 25 2020

I have 9 APs and one is running at 100 mbit while the rest are running at 1000 mbit. I did not run the cable for this but it is getting power from an injector at the switch. Any ideas why this would be happening? Thanks, Mark

MarkE · ‎Mar 16 2020

Thank you!

MarkE · ‎Mar 16 2020

Thanks Phillip, so no issues passing through a solid plastic? Mark

MarkE · ‎Mar 16 2020

I am looking for a cover to go over an MR that is in a school gym. A hinged clock cover would work but I'm not sure the metal won't affect the signal. Any ideas? Is there a carbon fibre version or something that will not weaken the signal? Thanks, Mark

Meraki

Community

About MarkE

MarkE

Community Record

Badges

Re: Why only 100 mbit on one device.

Re: Why only 100 mbit on one device.

Re: Why only 100 mbit on one device.

Why only 100 mbit on one device.

Re: WAP cover/protection

Re: WAP cover/protection

WAP cover/protection

Re: WAP cover/protection

Re: Why only 100 mbit on one device.