Meraki

Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About HamishMc

Re: MX65 Failover to 4G with Australian NBN through NTD

by in Security & SD-WAN
‎Mar 2 2020 2:15 PM
‎Mar 2 2020 2:15 PM
I was thinking along the same lines but with the Netgear 4G LTE Modem LB2120 - I've set these up before but where I had a router based on a Shuttle PC running Linux (and no NTD).  Seemed to work pretty well so was thinking about it here.   Appreciate your solution and, while it's not a solution for the MX65 to failover to 4G, it is an automated workaround - better than having to run to the comms cabinet and unplug/plug in cables.   Thanks    ... View more

Re: MX65 Failover to 4G with Australian NBN through NTD

by in Security & SD-WAN
‎Mar 1 2020 4:33 PM
‎Mar 1 2020 4:33 PM
Thanks for the Kudos but I still don't have an answer.   Last week and, again today, I had to manually unplug the cable from the Meraki to the NBN Co-NTD to force the backup 4G connection to activate. I still don't know how to ensure the 4G back up activates automatically when the NBN/Internet connection drops out. ... View more

Re: MX65 Failover to 4G with Australian NBN through NTD

by in Security & SD-WAN
‎Feb 25 2020 7:02 PM
2 Kudos
‎Feb 25 2020 7:02 PM
2 Kudos
Sounds a lot like scenario 2 - have had to wait longer than 5 mins.   Thanks for getting back so soon   ... View more

MX65 Failover to 4G with Australian NBN through NTD

by in Security & SD-WAN
‎Feb 25 2020 6:43 PM
‎Feb 25 2020 6:43 PM
New here and could not find and answer to this setup/question - although there might be one here that i've missed.   I am running an MX65 connected to the Australian NBN (National Broadband Network) provided over HFC (Hybrid Fubre Cable).   Essentially, the NBN/Internet connection is provided by Co-Ax cable into an NBN Co. supplied NTD (Network Termination Device).  The NTD connects to the MX65 on port 1.   I have a Huawei E3276 (this is howthe MX65 identifies the USB Dongle) plugged into the MX65. The MX65 shows the Cellular device as being ready.   However, when the NBN/Internet connection drops out, it is not failing over.  I have tested the USB Dongle in my laptop and it is working.   I suspect that the MX65 is still seeing and active WAN between the NTD and the MX65 - it's just that their no internet connection to the NTD.   Is there a way that the MX65 can identify that the internet connection has dropped off (from the NTD) and engage the 4G dongle ??   Many thanks     ... View more
© 2024 Cisco Systems, Inc.