Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About djmaquet
djmaquet
New here
Member since Dec 4, 2019
Dec 4 2019
Community Record
5
Posts
0
Kudos
0
Solutions
Badges
Dec 4 2019
8:05 AM
I set it up like that, rebooted and nothing would connect to my Guest Network. Did you have guest policies enabled or do you have a Guest Group created to limit bandwidth?
... View more
Dec 4 2019
7:46 AM
Can you show me the VLAN settings in your Merkaki? is 10.10.10.0/24 the subnet or the MX IP?
... View more
Dec 4 2019
7:42 AM
Thanks...the Z3 has the capability I believe. Just not sure how to set it up since the APs are really only broadcasting the SSID. But they don't show up in the wireless network settings on the Meraki.
... View more
Dec 4 2019
7:21 AM
The meraki is just plugged into a Netgear ProSafe GS728TP PoE switch..nothing special. I'm not a network guy, just wondering if there was something simple I could do with what I have. If I go another route, I will likely switch over to Ubiquiti.
... View more
Dec 4 2019
7:00 AM
I have a restaurant with a network consisting of a Meraki Z3 and 5 Unifi PRO AP's. This is hardware that was provided by my POS company, of which I have taken over network support. I have a guest network SSID created on the APs through the Unifi cloud controller. The Wireless networks are non-existent in the Meraki dashboard. I want to create a different subnet so customers can't access my LAN, and so I don't run out of available IP addresses. I have over 100 reserved for my POS system, printers, Smart TVs, etc. I can't set up a Meraki Guest network on an SSID because it currently shows no active SSIDs. If I do it on the Unifi controller, I'm pretty sure it won't work since the Meraki is handling all of the IP addresses. Does anyone have any suggestions on the best way to set this up? Maybe a VLAN (but on the Meraki or on the Unifi controller?).
... View more
© 2024 Cisco Systems, Inc.
