Meraki Community

Emanuel · ‎May 21 2021

Yes, it is good in some situation and I actually use it for collecting hourly data statistics. But from the GetNetworkClients I get VLAN/SSID and more that I need to be able to work on. If there was no limit in the number of api-calls, you could use a combination of calls to figure it all out 🙂 But I really would like to have a T1 on get network clients, I guess there is a reason for why that is missing....

Emanuel · ‎May 21 2021

Hi, This works fine for data, but I would like to collect "clients" in the same way. But, there is no t1 parameter. Sure you get the clients that produce data, but it lack alot of information about the clients... Regards Emanuel

Emanuel · ‎May 20 2021

Hi, It's possible to get data by T0 (start) and you get all from that time to current time. Or you can specify timespan to take from now back to the lenght of timespan. I miss T1, that would make it possible to get data for specific range. This is no big deal if you are to fetch data for a couple of networks and dont need to be precise, but if you need to collect this for 100 or 1000 networks, it will be harder... Anyone have a solution for this?

Meraki Community

About Emanuel

Emanuel

API Early Access Group

Community Record

Badges

Re: Get network clients for specific hour?

Re: Get network clients for specific hour?

Get network clients for specific hour?