Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Scott_L
Community Record
10
Posts
0
Kudos
0
Solutions
Badges
Oct 14 2024
6:59 AM
We have been having issues on Windows 11 devices when connecting to Secure Connect VPN the first time, the connection is established using TLS instead of DTLS resulting in poor performance. All subsequent attempts result in a DTLS connection. Rebooting the device will result in the first attempt negotiating TLS. This is causing users to connect multiple times to "fix" their performance issue. This behavior has been observed connecting to both an on premise MX and the Secure Connect datacenters. Support suggested enabling the routing and remote access service in Windows with delayed start (didn't work). Other than that they pretty much washed their hands and said they don't have an answer.
... View more
Jan 11 2024
1:36 PM
Firmware is 18.107.2 I did not try with autovpn disabled as I was not in a maintenance window where I could take it down. Ran speed test from a lan client and used the dashboard test. Same results both places. I'm bringing another site online tomorrow morning with the exact same config. I can try a speed test without the MX to verify the circuit.
... View more
Jan 11 2024
1:19 PM
Thanks but I'm not sending traffic through the VPN tunnel. A simple speed test not traversing the VPN caps out at 300Mbps on a 500Mbps fiber circuit. I can replicate this in two locations. That's why I asked in the original post if it caps all traffic. And support simply says "VPN enabled device".
... View more
Jan 11 2024
1:09 PM
Unfortunately that's not what supports says. Are they wrong? "Thank you for contacting Cisco Meraki Technical Support. My name is Joe and I'll be happy to assist you with this! After checking your network it looks like you have your VPNs enabled, and our data sheet here indicates that speeds will cap at 300 when testing through VPN enabled devices."
... View more
Jan 11 2024
1:00 PM
Can someone clarify how throughput works on the MXs? Using an MX67 for example. Firewall throughput is 600Mbps, VPN throughput is 300Mbps and Security throughput is 300Mbps. If you simply enable Auto-VPN and no security, does that mean you have capped the device at 300Mbps for ALL traffic weather it traverses a VPN tunnel or not?
... View more
Sep 25 2019
1:49 PM
Correct LAN1 with static routes for all the sites.
... View more
Sep 25 2019
1:27 PM
@Stealth_Network That's correct. All traffic to main site and only use broadband VPN tunnel if the Metro E is down.
... View more
Sep 25 2019
1:17 PM
I'm still in testing in a lab environment so I'll give this a try. I haven't setup any of the VPN yet but do have the static routes working for all of our vlans between sites so this was my next step to figure out.
... View more
Sep 25 2019
12:11 PM
Here's my scenario. I have multiple sites with both a Comcast ENS connection and a broadband Internet connection. Comcast is setup on LAN1 and broadband is on WAN1. At our main site we have additional 500MB dedicated Internet circuit. We want to route all Internet traffic back through the main site via Comcast connections and use the broadband only in a failover scenario (VPN). Is this possible and if so what's the best way to achieve this? Thanks, Scott
... View more
© 2025 Cisco Systems, Inc.
