Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About SchoolTechFW
Community Record
8
Posts
0
Kudos
0
Solutions
Badges
Sep 26 2019
5:32 AM
Cloning the network is a thought! Maybe I could do that safely, without endangering all that is actually working now. Thank you for the idea!
... View more
Sep 26 2019
5:30 AM
I have not upgraded. It might help, although I didn't see anything in the release notes that mentioned my issue. This is our central routing/gateway switch so if I botch it, it will be a major problem.
... View more
Sep 25 2019
6:00 AM
So it's been 2 week now since Meraki decided my ACL issue was a bug and forwarded it onto developers, which seems to be a black hole of some sort where things go in, but nothing (like information, or status reports) ever comes out. The support staff seems unable to get a status or any info at all on this. The only workaround Meraki support can suggest is deleting all ACLs and trying to add them back. I am not going to do that since it could leave me much worse off if I am unable to add the current ACLs back. So I am still stuck with our core switch missing key functionality - unable to add or edit ACLs. Wondering if I should explore a switch from another vendor and if I can find a more reliable one.
... View more
Sep 19 2019
5:44 AM
The MS250 is configured to route traffic between VLANs, and has been doing so for over a year and a half. The current ACLs have been working. I did just recently add a new VLAN which is the one I want to add ACLs for. But, I cannot even add a comment to an existing ACL without the errors. I just added the comment to the following rule and receive the errors upon trying to save the change.
... View more
Sep 19 2019
5:30 AM
That's a good suggestion. We are running MS 11.17 firmware. Looks like 11.22 is available on the Stable Channel.
... View more
Sep 18 2019
1:06 PM
I am unable to add or edit any ACLs on our MS250 switch. Upon saving any changes, including just adding a comment, I receive a long stream of errors like these: Must be 'both', 'ipv4', or ipv6'' For ACL rules applied to both IPv4 and IPv6, Destination address must be 'any' Must be 'both', 'ipv4', or ipv6'' For ACL rules applied to both IPv4 and IPv6, Destination address must be 'any' Must be 'both', 'ipv4', or ipv6'' For ACL rules applied to both IPv4 and IPv6, Source address must be 'any' Must be 'both', 'ipv4', or ipv6'' For ACL rules applied to both IPv4 and IPv6, Source address must be 'any' Must be 'both', 'ipv4', or ipv6'' For ACL rules applied to both IPv4 and IPv6, Destination address must be 'any' Per Meraki support, they think it is a bug because of a similar case they have open and have referred my case on to developers. So I need to get some ACLs set up for a new subnet and I have been stuck for a week now waiting for Meraki to figure out what is wrong. Has anyone else run into this? Any advice?
... View more
© 2024 Cisco Systems, Inc.
