Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Register or Sign in
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About githo
githo
Just browsing
Member since Sep 6, 2019
Sep 19 2019
Community Record
6
Posts
0
Kudos
0
Solutions
Badges
Sep 18 2019
7:58 AM
Yes Management VLAN is 1. So weird, I really don't get it. I just tried with a TP-link TL-SF1008D a belkin V300df and a D-Link DES-1008D All cheap, a bit older but still..
... View more
Sep 18 2019
7:49 AM
Hi, I(ve tried 2 brands (D-link and netgear) with the same results. I don't think they come any cheaper than this. 🙂 We have no access policies. Do you mean management VLAN with standard?
... View more
Sep 18 2019
7:07 AM
@cmr Sorry about the delay. I replicated the problem today. Computers with ip show up on the port information page. All mac addresses turn up in the routers arp table. Also the problem starts to manifest when I put on more than 1 computer behind the switch. If only 1 pc is turned on everything works perfect. I tried other simple non manageable/non vlan switches but the problem remains. It seems that you can't put another switch behind the MS.
... View more
Sep 10 2019
1:04 AM
@NolanHerring The port config: Type: Access Access policy: Open VLAN: 40 Voice Vlan: / Link: Auto negotioate RSTP: Enabled STP guard: disabled Unsheduled Port isolation: Disabled UDLD: Alert only
... View more
Sep 10 2019
1:01 AM
@cmr It's the most basic and cheapest switch (tried both netgear and D-link). It's a temporary solution due to cable shortage. When we put these switches on an untagged (access) port (VLAN 40) from our Zyxel switch everything works fine. On the meraki the clients get IP's as the should and they can access the servers. They just can't reach (or get a reply from) our gateway (ICMP), so no internet.
... View more
Sep 6 2019
7:09 AM
Hi MS120 switch with access port (native VLAN 40). When we connect a computer everything works fine (internal network + connection to our USG, who handles all VLANS, routing and WAN). When we connect a dumb layer 2 switch however (due to not enough cables atm) the internal network works fine except access to the USG (and everything behind it) for all clients connected to the dumb switch. This exact same setup (untagged VLAN40 port) on our old Zyxel GS1920 switch works just fine. What might cause this problem? Thanks
... View more
© 2024 Cisco Systems, Inc.
