Register or Sign in
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
- About Azamat
Azamat
Comes here often
Member since Jul 19, 2019
10-24-2019
Community Record
7
Posts
0
Kudos
0
Solutions
Badges
08-28-2019
05:38 AM
hi @PhilipDAth , please look at this article http://vmusketeers.com/2019/04/23/routing-from-a-single-public-ip-with-azure-firewall/ this guy has done it with Azure firewall. Is it possible with vMX100 ? my branches can access the internet via mx84, the problem is with my Azure vms, they cannot surf the Internet. Thanks
... View more
08-27-2019
12:36 PM
hi @Happiman yes I can ping www.google.com and www.vmware.com however, tracert and tracetcp give me the following output do you have any idea why ? Thanks!
... View more
08-27-2019
10:45 AM
hi @jdsilva FYI in vmx 100 Addressing and VLANs page doesn't exist thanks
... View more
08-27-2019
01:35 AM
Hello everyone, I hope you guys can help me. I'm really desperate on this We are using vmx 100 as a one-armed concentrator in our production environment, I have successfully deployed an appliance in a full mesh topology, created a route table and able to reach all our branch offices in site-to-site VPN. By default when you create a route table in Azure the Internet traffic is going through the azure backbone, but We would like to route all of our internet traffic out via a single IP which is our Meraki vMX 100. In Azure Route Table, I have created a new route (0.0.0.0/0) with the next hop type set to the virtual appliance 10.100.0.4. Well at this point everything works except I cant browse the internet. I can nslookup google.com, ping google.com 8.8.8.8 but unable to surf the internet. Please help me Thanks
... View more
07-22-2019
01:19 PM
Hi, @Raj66 thanks for the help. Yes, MXs have a public IPs and I successfully configured VRRP. I have another issue, however, I've created a static route on upstream L3 switch to VRRP virtual IP, but the route is not showing up in a routing table, but I can see it in the configuration, hence I'm not able to reach the branch offices. What could be the problem? IP routing is enabled on a switch and I'm able to route between, my VLANs. The model is Cisco 9500. Thanks!
... View more
07-19-2019
03:29 AM
Hi everyone, I would like to setup MX84 Firewall HA in one-armed concentrator mode and at this point, I'm very confused with provided documentation, and I hope you guys can help me. Is it possible to use the private IP range for VRRP instead of public? To send traffic over the VPN tunnel, a new route must be added on the L3 switch. Does this mean I have to create a static route to the public VRRP address? Here is my topology : Thanks
... View more
