I have 4 AP's setup in the topology I need. When I check RF under each AP I can see that mesh neighbors. I thought the AP's could be setup in Bridge mode? I have the SSID configured as Bridge and tagged each AP to be a part of that SSID. Each remote AP is coming up as repeater. Any suggestions or is this the way they operate? ... View more

Curious to know why I cant use the AP's as a repeater to extend the LAN? ... View more

I see what you mean but I want to keep the voice on the same vlan as the main building. The data can be separate via a L3 switch and routed across that wifi link. ... View more

sweet!. Hopefully it will work when I get my trial gear. This is for an outdoor setup so I don't want to install it all and then it don't work. Kinda sucks that these AP's can't just be setup in a point to point via line of sight and then I can configure the switch ports as a trunk. ... View more

yep. That would work also rather than a router. ... View more

I see where you are going with this and it looks like it would work but it would add more cost to the customer. The 2AP  method at the remote site I mean ... View more

Is there any way I could bridge the voice vlan rather than the data vlan and use a L3 switch to configure a vlan for the data on the remote end. In your tolpology the voice vlan would be in a different subnet than the main building. I prefer to keep the voice vlan on the same subnet. the data can be separated as it will be a POS station. ... View more