Great thread.  I have an additional question.   The great thing about using an MX in NAT mode with two WAN connections is that it can detect quality problems and failover traffic (i.e., not just a route hard down, but the preferred path having bad loss, jitter, delay).     If you set up MPLS connections on the LAN side, you do not get this feature, as far as I've been able to discover.  Can you possibly confirm if this Is accurate?   If you set up the MPLS connections as WAN connections with AutoVPN, you *would* get this behavior (especially desirable for VoIP).     However, the link you provided uses the one-armed-concentrator model of auto-VPN, which will eliminate the abiltiy to use the link tracking quality failover feature on the HQ side.  Is there some reason that the HQ end cannot also terminate the VPNs on WAN interfaces of a large MX operating in NAT mode?   ... View more

Hi again, Brecht.   I received this clarification: ' in the SD-WAN policies you are able to configure a primary uplink, that only is used for outgoing traffic, the Hub MX will always use its primary uplink instead of complying with the SD-WAN Policies.'   Does this help clarify it?   ... View more

Thanks for the reply, Brecht.     Yes, thank you: that particular situation is very clear.     However, I've also been told 'Unless the MXes are in  VPN Concentrator Mode, you have some limitations on the VPN Loadbalancing side'.     I've asked for clarification on this, but haven't heard anything more.  Also wondering what other issues (throughput?  features enabled?  #VPNs? etc.) there may be that might affect the answer.     Thank you,  Deb ... View more

Perfect!     Thank you very much, Phillip.  Appreciate your response, and having the link to that document. Deb ... View more