Meraki

DZA · ‎Aug 14 2019

Does anyone know if eBGP will still only be available in 1-armed concentrator mode, or if it will also be available in NAT mode moving forward as well?

DZA · ‎Aug 12 2019

Hi Philip, thanks for the detail. Yes we are using straight MX67s with a USB 4G modem. We have a few sites were we have a kiosk in a shopping center where we can only use 4G for the network connection, or where we can't get an IPVPN or it's too expensive and we want to use the 4G as a backup connection if the Internet link fails. Can you build AutoVPN tunnels in both of these scenarios, either as a primary 4G connection or failover AutoVPN traffic to cellular?

DZA · ‎Aug 12 2019

Hi, Can you use the cellular interface on an MX67 for SDWAN/AutoVPN? Does anyone have this working either as a secondary failover or a primary SDWAN uplink?

DZA · ‎Aug 9 2019

Thanks CptnCrnch. I assume that I would then need to tie the fw session & the netflow session to correlate the traffic for that session? All of our traffic will be flowing through a FW which provides us with the data when the flow ends. We are looking into the possibility of dropping the firewall logs for these sessions as we should also get them from the MX. However before doing this we'd want a 1:1 of the information we receive. I know that Splunk has a flow collector and then may tie in easier, but we're currently using a different product for netflow.

DZA · ‎Aug 9 2019

Thanks, makes sense.

DZA · ‎Aug 8 2019

Hi, We are exporting MX flow logs to Splunk. Does anyone have anymore detail for the below: - what does the value "374543986.038687615" refer to for the MX flow example in the below link? Is it usable in anyway or is it just an internal reference point. https://documentation.meraki.com/zGeneral_Administration/Monitoring_and_Reporting/Syslog_Event_Types_and_Log_Samples#Meraki_MX_Security_Appliance - what is the difference between "flows", "ip_flow_start" and "ip_flow_stop" in the flow records. - is there any possibility or is it planned for upcoming releases to export the sent and received data volumes in flow logs.I saw someone else posted the below. I'll see someone else posted the below. https://community.meraki.com/t5/Security-SD-WAN/Wish-Include-sent-and-received-data-volumes-in-MX-flow-logs/m-p/28049

Meraki

Community

About DZA

DZA

Community Record

Badges

Re: Active/Active AutoVPN Design Guide

Re: SDWAN/AutoVPN on Cellular Interface

SDWAN/AutoVPN on Cellular Interface

Re: MX Flow Logs

Re: MX Flow Logs

MX Flow Logs