Meraki Community

ehsan2305 · ‎Aug 27 2019

Dear Sir, My MX64 device WAN static IP is :- 192.168.8.104 And VPN status as :- NAT traversal :- My question is that port : 48822 in NAT type are fixed for each cisco meraki device or if MANUALLY : PORT FORWARDING as :- Than we have to type ip = 192.168.8.104 and port : 48822 in above case we have to use same port or we can use any unreserved port. Because there is a device which is giving as : - "NAT type: Unfriendly" or "VPN Registry: Disconnected" Thanks and regards.

ehsan2305 · ‎May 16 2019

sir in my meraki mx auto vpn hub device if i deny local sub net e.g deny 192.168.10.0/24 0.0.0.0 for wan1 and wan2. and then allow all. Do my auto vpn with the spoke device will work.

ehsan2305 · ‎May 16 2019

If I block all ports for outgoing traffic and allow only the ports that you mentioned below than auto vpn between meraki mx will work and there will be no outgoing internet traffic. Actually my requirement is to only allow vpn between meraki mx device with their local subnets, but user should not allowed internet browsing.

ehsan2305 · ‎May 15 2019

port need to only allow for auto vpn in meraki mx

ehsan2305 · ‎Apr 30 2019

Dear Sir, Cisco Meraki Auto VPN site to site features can connect as site to multi-site. Example as :- one head office and 10 branches. Can all the branches connect to head office using auto vpn features.

Meraki Community

About ehsan2305

ehsan2305

Community Record

Badges

"NAT type: Unfriendly" or "VPN Registry: Disconnected"

auto vpn and local subnet

Re: auto vpn port

auto vpn port

cisco meraki mx64