Also, check under "Network-wide" > "General" in the dashboard to verify that the Local Device Status Pages Enabled option is selected in the drop down.   ... View more

Good question CMR.  The OP titled the thread "Setup New Switch".  It is a fact that the MX450 is a firewall. ... View more

I was referring to the existing switch that you would be connecting the MX450 to.  Merakian's reply above clarifies what will happen when utilizing Internet 2 as opposed to Internet 1 on the MX. ... View more

Good point, Merakian ... View more

If connecting to an existing the MX450 to an existing switchport (assuming Catalyst or other) to get an address via DHCP:   1. Be sure that the switchport is a member of a VLAN that has a DHCP pool set up. 2. Also, be sure that the port you connect it to is an access port and not a trunk port. ... View more

I would start by analyzing your dynamic path selection for SD-WAN.  Also check to see if VPN load balancing is turned on. ... View more