Meraki

Community

About AlexLIO

Re: Meraki Warm Spare Failover

by in Security & SD-WAN
‎Feb 7 2019 8:25 PM
‎Feb 7 2019 8:25 PM
No problem. this was theoretical. We have the MX84s but only a primary 100mbps service currently. We're looking at our options on setting up a new primary so we'll make sure to not exceed 500mbps! ... View more

Re: Meraki Warm Spare Failover

by in Security & SD-WAN
‎Feb 7 2019 8:16 PM
‎Feb 7 2019 8:16 PM
Hi Nolan,   Thanks for the quick response.    Correct, using vIP on the MX84s.    I thought that was the case but just wanted confirmation. Not exactly what we're after but its definitely better than no failover.   Thanks again. ... View more

Meraki Warm Spare Failover

by in Security & SD-WAN
‎Feb 7 2019 8:05 PM
‎Feb 7 2019 8:05 PM
Hi All,   I have a question in regard to the warm spare failover process.   Here is the configuration:   2 Separate services - ISP 1 - 1GBPS. IPS 2 - 500MBPS   Primary MX - Uplink Port 1 from ISP 1. Uplink Port 2 from ISP 2. Secondary MX - Uplink Port 1 from ISP 1. Uplink Port 2 from ISP 2.   I understand how failover works on the whole but I want to know what happens in this particular scenario. However unlikely it is, what happens if I lose the Uplink on Primary MX 1 Port 1?   Does it failover to Primary MX 1 Port 2, or does it failover to Secondary MX 1 Port 1?   The reason I ask is that obviously if the 1GBPS service is still available on the secondary port 1, we'd ideally like to use this rather than the 500mbps service on the Primary MX on Port 2.   Any advise would be much appreciated.   Thanks   ... View more
© 2024 Cisco Systems, Inc.