Meraki Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About AZAzure

Re: How to enable 160MHz channel width on Meraki MR52?

by in Wireless
‎Jan 27 2019 9:39 AM
‎Jan 27 2019 9:39 AM
You'd better check this: https://ark.intel.com/products/99446/Intel-Wireless-AC-9560 AC 9560 is a 2x2 wireless card that supports 160 MHz. I believe it is integrated into multiple mobile platforms. And actually I'm using that card.   And I also have a challenge for you: Find ANY device that supports 4x4 MIMO. Integrating 4 antennas is much more difficult than replacing a current wireless card with an AC9560. ... View more

Re: How to enable 160MHz channel width on Meraki MR52?

by in Wireless
‎Jan 24 2019 8:47 PM
‎Jan 24 2019 8:47 PM
Thank you Dave. I understand what you said. But I just want to have a method to enable it - at least so that we can measure the RF performance of 160MHz in our environment. ... View more

How to enable 160MHz channel width on Meraki MR52?

by in Wireless
‎Jan 24 2019 7:03 PM
‎Jan 24 2019 7:03 PM
We have a MR52 which the datasheet claims supporting 160MHz channel width. However I couldn't  figure out how to set it up. Then I come up with this article from Meraki, which mentions that 160 MHz is not suitable for enterprise deployments or supported in the Meraki dashboard.   For me this sounds suspicious. I would assume the claim from the datasheet is false advertisement if there is no way to enable 160MHz. ... View more
© 2024 Cisco Systems, Inc.