Hello @crafter,    Hope this issue is resolved for you. Just wanted to point out that the Meraki MV doesn't have any layer 3 firewall functionality therefore it can't allow or block network traffic . If you are suspecting any network IP/Port is blocked in the concern network then that can be verified by analyzing the packet capture taken from a Network switch or firewall upstream to the camera. If the camera is connected to Meraki Switch / Meraki firewall then Meraki Support team can assist you on analyzing the network traffic upon creating a support ticket. ... View more

Hi @Mackadelic,    Hope this issue is resolved for you. Were the affected devices enrolled through ADE ? Just wanted to point out that if a device is enrolled through ADE then ADE settings pushed to the device is required to be removed from "Systems Manager > Manage > ADE" page before factory resetting the device to fully unenroll the device from Meraki SM. Following kb has step by step guidelines on unenrolling an ADE enrolled device.   Uninstalling Systems Manager and Removing Managed Devices   ... View more

Hi @BrandonModdes and @ekramer ,   Thanks for discussing this issue in Meraki Community. If the command line tool from Device details page is not working, please consider to check if you can send commands to enrolled devices from "Systems Manager > Monitor > Command line" section. Please also consider to create a Meraki support case so that the Meraki support team can check if there's any ongoing issues reported for this feature and assist further.   ... View more