Meraki

NotHalfVast · ‎Feb 4 2025

No, the MV88 doesn't have the holes at the corners to match up with the mounting holes for the MV48 arm bracket. I suppose I could drill it out, but I was trying to avoid having to do that.

NotHalfVast · ‎Feb 3 2025

The servers haven't been installed yet, so a concern was that the additional wiring and equipment activity would risk damage to the MV33 if it was mounted to a cable race. I do have an MV13, but I need the MV33 in this instance because there are two doors to cover and they are around the corner of that wall from each other. The alternative would be to use two MV13 cameras to cover the doors, but then I would need a third one to cover the servers. The 33 will see everything at once if I can get this mount figured out.

NotHalfVast · ‎Feb 3 2025

I have a server room I need to cover with an MV-33 camera. I can't put it on the ceiling because the cable races that currently hang from the ceiling will block the view. The best location is going to be the outside corner of a wall to cover two different doors. I have an MA-MNT-MV-48 Wall Mount Arm Bracket to get the MV-33 away from the wall, but I can't find an outside wall corner bracket with holes to accept that MV-48 mount. The only one that looks like it might work I found at https://www.surveillance-video.com/accessory-mnt-pcnrip.html?gad_source=1&gclid=CjwKCAiA74G9BhAEEiwA8kNfpVfSrK1-JMtB5gLGIKm9hMpWPix4PCMh9i3HpZfepuX830PefUKY_RoC-DYQAvD_BwE

Meraki

Community

About NotHalfVast

NotHalfVast

Community Record

Re: Corner Bracket for a Wall Mount Arm (MA-MNT-MV-48)

Re: Corner Bracket for a Wall Mount Arm (MA-MNT-MV-48)

Corner Bracket for a Wall Mount Arm (MA-MNT-MV-48)

Re: Corner Bracket for a Wall Mount Arm (MA-MNT-MV-48)