Any update on this? ... View more

One way is to view the txt file that is created and shows the APs that were rebooted. I also verified if an AP was rebooted by running the script and going to a different office where the AP should have rebooted, but didn't. ... View more

Thanks for the quick response. I do use "-AP" since that should match every APs name, but it doesn't. I changed it to just "AP", but that actually rebooted less than using "-AP". I then changed it to "Room" since where I see most problems are in the APs that have "Room" in the name, but again, that didn't reboot every AP that had "Room" in their name.   What I also noticed when I used "-AP", it was always the same APs that were rebooted. I just have one network, all the APs are in it.     ... View more

Thanks for the script, but when I use it, not all the APs get rebooted. All my APs name end with "-AP" but about a third get rebooted. Is there a way to just say reboot all APs? ... View more