Hello team,   As someone who only has experience with Meraki WiFi and classic Cisco solutions, I need some advice regarding new Meraki setup. We plan to implement completely new network and because the building is still in renovation phase we would like to onboard the devices, form the stacks, do the upgrade if necessary and so on and that way prepare as much as possible in advance for installation. Perform some kind of staging. My plan was to power on the devices connect them to the uplink (they will obtain IP from DHCP) and get them online. Is it recommended while devices are still in this staging area to configure them over the dashboard? They will get all the information like hostnames, VLANs, subnets and so on, but will also need to have different static mgmt addresses. When you change mgmt VLAN and address and apply it to the device I suppose that device will lose connectivity with dashboard? Or is it better option to wait and when devices are installed in the racks and everything is connected, then to do initial configuration over the local status page and set IP addresses and VLAN tagging manually, because we don't have any device with DHCP on site, only P2P link to ISP. After device is online in the dashboard apply configuration as planed.  I suppose that with second option you have smaller chances for error and potential tshoot on the day of installation. All advices are welcome 😁 ... View more