Radio transmit power were not increased as setting.

[Tu__Nguyen]

We are installing MR. 56 APs for a high ceiling room (11 meters H), that required maximizing transmit power as much as possible. However, the actual power (~13 dBm) were not reflected as setting (target power: 27 - 29 dBm) as picture below.

Does any one experienced the same issue and can resolved?

Thanks

Andrew.

[Brash · Accepted solution]

Take a look at the max power limitations and see if any of these apply to your setup

https://documentation.meraki.com/MR/Radio_Settings/RF_Profiles#Max_Radio_Power_Limitations

[Tu__Nguyen]

Thanks for your ref.

After searching, it is clearer that each AP model has specific power limitation (only show when manual setting), as below:

Thanks

[PhilipDAth]

On a different issue - I would reduce your maximum channel width to 20Mhz.  Otherwise, you are likely to get a lot of co-channel interference with the APs so high.

[Tu__Nguyen]

Thanks for expanding with related informatio.