Meraki Switch and AP Vlan Tagging

[MichaelvanBal]

I have a Meraki AP with 3 SSID's with different Vlan (22 - 26 - 192)

How do i need to setup the Meraki Switch (MS225-48LP) Port.

Trunk / Access point (I assume Trunk) but then i do that I got no signal and AP will go down, any idea's how to setup the Switch port?

PS: Our CISCO ASA will provide the VLAN's and this is working!

[PhilipDAth]

You want to use a trunk port.

The access point (will by default) expect to be able to get to the Internet on the native vlan (usually vlan 1).  The SSIDs will be bridged though to the other VLANs (assuming you configured bridging for the SSID settings).

[Uberseehandel]

You also need to make sure that the trunk port allows the Management VLAN as well as the SSID VLANs.

[MichaelvanBal]

i now have

Trunk port using native VLAN 1; allowed VLANs: 1,4,21-22,26,192

Access Point Lan Settings

IP X.X.4.X
Vlan 4

[PhilipDAth]

And vlan4 can get out to the Internet ok?

Does the local status page of the AP report any issues, like DNS, default gateway, ARP, etc?