I have an MR42 that constantly shows high latency even after rebooting the AP and power cycling the port. Cable test shows no issues. Channel config is set to auto.
![7.2.HW latency2.PNG 7.2.HW latency2.PNG](https://community.meraki.com/t5/image/serverpage/image-id/6827iA034EFB46D05FA40/image-size/large?v=v2&px=999)
But when I ping it, to the AP and from the AP to the internet, there's normal latency:
![7.2.HW latency1.PNG 7.2.HW latency1.PNG](https://community.meraki.com/t5/image/serverpage/image-id/6828i6069C680DA9FB67F/image-size/large?v=v2&px=999)
It also shows it meshing with nearby APs but the distance shown is way too high:
![7.2.HW.PNG 7.2.HW.PNG](https://community.meraki.com/t5/image/serverpage/image-id/6829iFB4311F1EF565610/image-size/large?v=v2&px=999)
So if the ping shows low latency, why is the latency to the clients so poor? It's a big place with few neighbors whose signals could interfere and the other APs nearby don't seem to have an issue. (bldg 7 and 1 are connected so it should be connecting to both)
Firmware 26.2
Haven't tried replacing it yet, quite a drive and want to see what the forum knows about it. Glitch or time to replace this AP?