How to control the Bonjour forwarding from specified source vlan to destination vlan

[VincentZHU]

Hi,all

How I control the Bonjour forward from specified source vlan to destination vlan

My scene has total 3 floors, two SSIDs and per vlan/subnet per floor for each SSID, detail as below.

SSID-A

1F:vlan 101 with bonjour-serivice-1F

2F:vlan 102 with bonjour-serivice-2F

3F: vlan 103 with bonjour-serivice-3F

SSID-B

1F:vlan 201

2F:vlan 202

3F:vlan 203

And I want to client of SSID-B on 1F only can see bonjour-service-1F,and client of SSID-B on 2F only can see bonjour-serivice-2F ,etc.

But when I enable bonjour forwarding in SSID-B with destination vlan 201/202/203, all bonjour-service-xF can be seen in each floor.

How I control bonjour forwarding with special source vlan?

Thanks

[VincentZHU]

For MX bonjour forwarding,I can config "Service VLANs" and "Client VLANs",but at MR bonjour forwarding, I can only config destination VLAN ID i.e. Service VLANs. unfortunately,I didn't deploy MX in my network.

How if I only allow VLAN 101 and 201 on access switch trunk port at 1F, and allow VLAN 102 and 202 at 2F?

Thanks to your help.

[GreenMan]

Access Points are Layer-2 devices only - if you want traffic to flow between VLANs you need a Layer-3 capable device;  a router or Layer-3 switch or an appropriate routing security device, like an MX.