Meraki Community

Yazmin2 · ‎Jun 23 2023

Good morning, to connect 6 MR44 Access Points without the need for PoE power, what MS Switch could you propose?

alemabrahao · ‎Jun 23 2023

You need to calculate it. For example 740W divided 30W (PoE+) = 24

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

View solution in original post

alemabrahao · ‎Jun 23 2023

Check it at the documentation.

https://meraki.cisco.com/product-collateral/ms-family-datasheet/

You can use a power injector too.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Yazmin2 · ‎Jun 23 2023

¿Cuántos puertos máximos admite PoE+ en el Switch MS120-24P y MS120-8FP?

alemabrahao · ‎Jun 23 2023

You need to calculate it. For example 740W divided 30W (PoE+) = 24

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

decassuncao · ‎Jun 23 2023

At least .af PoE

PhilipDAth · ‎Jun 25 2023

Note that although the MR44 will run on 802.3af (15.4W) the MR44 will retard its functionality. To get all the capabilities you need 802.3at power.

Meraki Community

Access Point MR-44

Access Point MR-44