Is this Possible? Multiple Vlans with mesh

romualdt
Here to help

Is this Possible? Multiple Vlans with mesh

Have not been able to get this to work (yet) starting to wonder if it is even possible...

 

Multiple buildings each with a ms210 connected with MR74 back to the main office.  we segment vlans based on device/traffic type ( MGMT,Data,Camera,Voice...) each building will one or more of each device type.

 

I followed this document (https://documentation.meraki.com/MS/Layer_3_Switching/Layer_3_Switch_Example)  to get it working initially  using wired uplinks to make sure all the routing works.  Now that I try and switch out the physical uplinks for wireless cannot get vlans to pass.

 

Glab.png

4 REPLIES 4
BrandonS
Kind of a big deal

Nope.  Only one VLAN this way.  Try Engenius for a proper, inexpensive wireless bridge. 

- Ex community all-star (⌐⊙_⊙)
NolanHerring
Kind of a big deal

Yeah your going to need to find another solution, UBNT has good gear for this.

 

It's a shame really that they don't support it  =(

 

 

https://documentation.meraki.com/MR/Deployment_Guides/Mesh_Deployment_Guide

 

Ethernet bridging

The gateway access point may be configured to connect to a trunk port and trunk SSIDs to different VLANs. Repeaters will also serve SSIDs trunked on different VLANs. However, only one SSID & associated VLAN may be configured to bridge wired clients across a mesh link on a repeater access point's Ethernet port. A mixture of wired clients and Cisco Meraki access points attached to one MR repeater interface is not a supported deployment configuration. This is due to the auto detection mechanisms that Cisco Meraki access points use to infer when they should function as a gateway or a repeater.

 

Nolan Herring | nolanwifi.com
TwitterLinkedIn
PhilipDAth
Kind of a big deal
Kind of a big deal

To make this work you need to put each MS210 into layer 3 mode.  You ideally want to put the bridged network into a single unqiue subnet - this will be a transit network.  Each site will end up having its own unique subnet for each VLAN - rather than being an extension of the main site.

 

So all traffic to and from the sites is routed - not bridged.

 

 

This article very briefly discussed this.

https://documentation.meraki.com/MR/WiFi_Basics_and_Best_Practices/Extending_the_LAN_with_a_Wireless...

 

You can read about enabling layer 3 mode here:

https://documentation.meraki.com/MS/Layer_3_Switching/MS_Layer_3_Switching_and_Routing

GIdenJoe
Kind of a big deal
Kind of a big deal

The Cisco Aironet AP's with WLC do support wireless mesh with ethernet bridging and VLANs.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels