HI I have setup a LAG to my Dell switch stack.
I have put port 5/6 on MS120 into a LAG , On the Dell stack I have created a LAG with port 23 on both switches in my switch Stack. (g1/23 & g2/23).
Now when I look at the Meraki port 6 has CDP/LLDP data but port 5 in the LAG dose not. Plus the Dell is not shown in the L2 topology view.
Now Yesterday when I tried changing the setting on the Meraki dashboard under the CDP/LLDP info when looking at port details I had a popup thing saying all VLAN match that too now is not showing up.
So I have two question
1 why is the Dell switch not showing up in the L2 topology view.
2 why dose only port 6 on the Meraki show CDP/LLDP info not port 5.
One the Dell both ports and LAG is set to advertise CDP/LLDP information. The LAG is in trunk Mode so on Dell switches it called Switch profile . which is trunk mode.
Now according to Meraki Docs I need to disabled Transparency but I have no idea what that means no setting by that name.
Note: Dell PowerConnect switches have LLDP disabled and Transparency enabled by default. In order to make use of the topology featurein Dashboard, LLDP must be enabled and Transparency must be disabled. The topology will not update immediately and may take some time and is not real-time.
There are several ways and this is one. Go to Switch/Switch Ports and displayed the list of aggregated ports using the "is:aggregated" filter.
Hover your mouse over to the right of the aggregated port group and click "details". Make sure it lists the correct number of ports in the group in the "using ports" section.
sorry about all these images. Now when I click the menus to view switch ports in the dashboard I only get LLPD data for port 5 if I click details from where you said to on the port view . If I use the menu and go to switch then click on the ports I only get CDP/LLDP data on port 6.
Now the other day I also used to get a VLAN match item under CDP/LLDP info on details page. and If I click on it it was say VLANS match that is no longer showing up either. I have try added other port to the LAG on the dell switch and change which port in plugged into the dell with no help only port 6 on meraki gets CDP/LLDP data.
The port channel looks like it is formed correctly on the Meraki side. I think you might need to examine this issue further from the Dell side.