Trunking Native Cisco IOS Switch to Meraki MS350 or 210

[Laird]

Im trying to set up a trunk in between a Meraki MS350  a Cisco 3560-12 switch.

There are 3 vlans

101 for data      10.96.168.0 /22

172 for WIFI      10.96.172.0  /22

201 for voice     10.98.168.0 /22

Both The WIFI AP and the phone register correctly with the respective controllers and subnets but the data vlan is blocked

CST: %SPANTREE-2-RECV_PVID_ERR: Received BPDU with inconsistent peer vlan id 1 on FastEthernet0/12 VLAN101.

CST: %SPANTREE-2-BLOCK_PVID_PEER: Blocking FastEthernet0/12 on VLAN0001. Inconsistent peer vlan. CST: %SPANTREE-2-BLOCK_PVID_LOCAL: Blocking FastEthernet0/12 on VLAN0101. Inconsistent local vlan.

US-758-B8-SHP-S5#sho int trunk

Port        Mode             Encapsulation  Status        Native vlan

Fa0/12      on               802.1q         trunking      101

Port        Vlans allowed on trunk

Fa0/12      1-4094

Port        Vlans allowed and active in management domain

Fa0/12      1,101,172,201

Port        Vlans in spanning tree forwarding state and not pruned

Fa0/12      172,201

interface FastEthernet0/10
switchport access vlan 101
switchport voice vlan 201
srr-queue bandwidth share 1 30 35 5
priority-queue out
mls qos trust device cisco-phone
mls qos trust cos
auto qos voip cisco-phone
spanning-tree portfast
service-policy input AUTOQOS-SRND4-CISCOPHONE-POLICY
!
interface FastEthernet0/11
switchport access vlan 172
srr-queue bandwidth share 1 30 35 5
priority-queue out
mls qos trust device cisco-phone
mls qos trust cos
auto qos voip cisco-phone
spanning-tree portfast
service-policy input AUTOQOS-SRND4-CISCOPHONE-POLICY
!
interface FastEthernet0/12
switchport trunk encapsulation dot1q
switchport trunk native vlan 101
switchport trunk allowed vlan 1,101,172,201
switchport mode trunk
!

Any suggestions are most welcome

[PhilipDAth]

First change to using mst on the 3560.

spanning-tree mode mst

Next decide what is the core switch, and change the spanning tree priority on that switch to make sure it is the root.

[PhilipDAth]

I wouldn't trunk vlan 1 and use a native vlan at the same time.  Perhaps try:

interface FastEthernet0/12
switchport trunk encapsulation dot1q
switchport trunk native vlan 101
switchport trunk allowed vlan 101,172,201
switchport mode trunk

[JWill]

I ran into an issue like this with a Nexus. Had to go with:

spanning-tree port type edge

To keep ST in check. Changing root priority did not work for me, but the edge port did.