SecurePort on MS355

DevOps_RC
Getting noticed

SecurePort on MS355

Good Afternoon, We have recently started to deploy MS355 and C9162/9164 throughout our organisation. First four sites went well, apart from a few issues not relating to Meraki. However, we are now deploying at one of our primary sites and the SecurePort process doesn't seem to want to complete, so the AP's check-in correctly, and clients can authenticate, but they receive IPs, nor allowed to pass any data. Looking at the switchport config it's set to only pass the management Vlan, but clients should get dropped into others.

I've logged a call and currently speaking to a Meraki representative, but has anyone seen this issue?

0 REPLIES 0
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels