Meraki MS - management VLAN

Proxy
Here to help

Meraki MS - management VLAN

Hi, I have a question on setting the management VLAN on the MS series switches.  Imagine that the switch uplink is connected to a trunk port on another switch with the following config (U-101, T-10,20,30,50,999)

- Native (untagged) VLAN-ID 101 (this is a parking lot / blackhole empty VLAN)

- Tagged VLANs 10,20,30,40,999

- Note that management should be tagged in-band management on VLAN 999

 

What's the difference between setting the VLAN-ID to 999 in the front-page switch settings on the dashboard, and leaving the management VLAN under switch settings as VLAN1?  The way I understand this, the management VLAN under switch settings is to set the management VLAN network wide - for all switches - and setting the VLAN under LAN IP would over-ride this by exception.  Did I understand this correctly? 

 

1 REPLY 1
PhilipDAth
Kind of a big deal
Kind of a big deal

Your understanding is correct.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels