MS390 - LLDP topology issues

Trooper
Here to help

MS390 - LLDP topology issues

In the topology screen, the MS390's don't always show their uplink port correctly.

 

Below is a screen shot of my topology.

 

I've circled two MS390's.

Both show their uplink port going to an unknown device.

For both, port 1 should be going to the switch to the left, but it says no LLDP info.

 

And on the upper 390, no link is shown going to the stack to the right.

But the lower one does show it.

 

I've got a third 390 (not shown), where the topology is working correctly.

 

Anyone else seen this or know of a fix?

Rebooting doesn't fix it.

 

 

MS390.JPG

3 REPLIES 3
cmr
Kind of a big deal
Kind of a big deal

I think that is pretty good for Meraki topology, look at this complete Meraki site where the diamond on the left is the MX pair at the bottom right...  I despair!

Screenshot_20200715-213828_Chrome.jpg

cmr
Kind of a big deal
Kind of a big deal

Just realised that if I had unticked the label all devices box, I wouldn't have had to scratch them out! 🤔

At least I'm not alone 😀

 

The topology usually figures itself out - sort of.

 

So far, not overly impressed with the 390's.

 

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels