MS120-24P - The link is dropping from 1Gfdx to 10fdx every night

HungPhan
Conversationalist

MS120-24P - The link is dropping from 1Gfdx to 10fdx every night

Hello everyone,

Currently, i have a POS machine was connected to port 10 on MS120-24P swith. It usually changes from port: 10, old: 1Gfdx, new: down to port: 10, old: down, new: 10fdx every night.

This port was configured at Auto-negotiate mode. 

I supposed that the time from 22:00 to 8:00 data usage reduced that why this port kept on 10 Mbps during this time.

Then it goes back to 1Gbs afterthat.

Can you advise me something on this?

Thank you,

 

1 REPLY 1
Brash
A model citizen

This is typically seen when devices go into power saving mode.

The following thread has some additional detail

Switch port change link speed - The Meraki Community

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels