MS - Cable test not working with the new UI

[RaphaelL]

Hi ,

Not sure if I'm the only one experiencing this but I can't perform cable tests with the new UI. Everything else works fine ( packet capture , port cycles  )

Running MS 17.1.4 on a MS350. I have tested 10 switches so far.

The tools tab works just fine.

Maybe Ryan is already aware of an existing case 😅

[RWelch]

Works fine for me on MS18.1.3.1 (tested) on MS355-24X2 and MS130-8X.

Edit: I also tested a MS350-24 on MS18.1.3.1 and it worked fine as well.

[BHC_RESORTS]

Huh, I have some similar but different results. Some ports seem to work OK, some don't. This particular run is a longer one, maybe 70-80 meters. Shorter runs seem to work fine. MS125-48LP running 17.2.2. Also noticed the uptime doesn't seem to count the reboots for software updates?

[RaphaelL]

Uptime was discussed yesterday in this thread : https://community.meraki.com/t5/Switching/Incorrect-Device-Uptime/m-p/286033

[RaphaelL]

Can any of you try a port that is down/disconnected ? Ports that are Up are working on my end , only ports that are down are affected. odd..