MA-PWR-640WAC

SOLVED
Eddie01
Getting noticed

MA-PWR-640WAC

Hi,

 

I have a customer requesting the MA-PWR-640WAC as spares but they want to use a locking power cord, not the one sold by Meraki. Below is the link of the cord they need, is this power cord supported?

 

https://www.apc.com/shop/us/en/products/Power-Cord-Kit-6-ea-Locking-C13-to-C14-1-8m/P-AP8706S-WW

 

Regards

1 ACCEPTED SOLUTION
cmr
Kind of a big deal
Kind of a big deal

Those power supplies require the C15 connector, not the C13.

View solution in original post

7 REPLIES 7
cmr
Kind of a big deal
Kind of a big deal

Those power supplies require the C15 connector, not the C13.

Eddie01
Getting noticed

Thanks

cmr
Kind of a big deal
Kind of a big deal

@Eddie01 they are a high current connector, you need something like these as APC don't seem to do the right cables:

 

Black IEC 60320 C14 to Locking C15 15A A-Lock Power Cords (worldcordsets.com)

Eddie01
Getting noticed

ok I'll check the datasheets on both cables.

 

Thanks

PhilipDAth
Kind of a big deal
Kind of a big deal

MA-PWR-640WAC has a little loop on it.  If you run the power cord through that loop you can't pull the cord out.

 

Perhaps you can get a cord with a locking fitting on one end, and a "standard" fitting on the other to go into the Meraki power supply.

Good to know.

 

Thanks

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels