MA-PWR-640WAC

[Eddie01]

Hi,

I have a customer requesting the MA-PWR-640WAC as spares but they want to use a locking power cord, not the one sold by Meraki. Below is the link of the cord they need, is this power cord supported?

https://www.apc.com/shop/us/en/products/Power-Cord-Kit-6-ea-Locking-C13-to-C14-1-8m/P-AP8706S-WW

Regards

[cmr · Accepted solution]

Those power supplies require the C15 connector, not the C13.

[Eddie01]

Thanks

[Eddie01]

Would this work?

https://www.apc.com/shop/us/en/products/Power-Cord-Kit-6-ea-Locking-C19-to-C20-90-Degree-1-2m/P-AP87...

[cmr]

@Eddie01 they are a high current connector, you need something like these as APC don't seem to do the right cables:

Black IEC 60320 C14 to Locking C15 15A A-Lock Power Cords (worldcordsets.com)

[Eddie01]

ok I'll check the datasheets on both cables.

Thanks

[PhilipDAth]

MA-PWR-640WAC has a little loop on it.  If you run the power cord through that loop you can't pull the cord out.

Perhaps you can get a cord with a locking fitting on one end, and a "standard" fitting on the other to go into the Meraki power supply.

[Eddie01]

Good to know.

Thanks