Inter VLAN MS250

[nst1]

I have an MS250-24P and it is the only device in my Network.

in the configure 4 different VLANs, try to do a test from the Tools tab of the MS pinging between VLAN but it was not possible to show me "Loss rate: 100%, Average latency: N / A"

where can I configure Inter VLAN ??

[NolanHerring]

Did you create L3 SVI's on that switch for each of those VLANs?

[nst1]

Yes, for example 

10.130.156.0/24    10.130.156.1

150.130.170.0/24  10.130.170.1

150.130.190.0/24   10.130.190.254

[NolanHerring]

Oh wait....are you trying to ping the SVI from the same switch they live on? I don't think that will work. Try doing it from another switch that connects to this 'core' if you can.

I just tried it on a switch, it is unable to ping itself.

[nst1]

@NolanHerring
Ok, I just have that switch, I could not do what you say.

But if I have two computers connected in the same swicth with different VLAN should I ping without any problem correct ???

[NolanHerring]

They should yes

[kYutobi]

Is your trunk port allowing all VLANs? You're saying that you have a MS250 do you have anything else in the equation? Other switches etc?

[DN]

Unless you have some policy added to deny communication between the Vlans , pinging from one PC to another should go through . Let us know once you tried 🙂 .