Future IPv6 Layer 3/Routing support for MS - which hardware?

plumdev
Here to help

Future IPv6 Layer 3/Routing support for MS - which hardware?

Hello all, tried searching "ipv6" in the MS/Switching forum, but didn't find anything recent.

 

I'm trying to plan ahead and figure out what hardware requirements will be for IPv6 static routing in the future.

 

Or perhaps I should step back and first ask the most basic question: Is IPv6 static routing a planned feature for MS?

 

If [hopefully] so, will it be supported on all MS switches that currently do L3? E.g., if I purchase a MS250 now, will new firmware eventually enable IPv6 static routing?

 

Or are there known hardware limitations such that only certain models/lines be able to support IPv6 routing?

 

Stretch question: any kind of approximate timeline? 🙂

2 REPLIES 2
alemabrahao
Kind of a big deal
Kind of a big deal

On beta fiwmware MS 15.14.2 It was add, but just to MS 390:

 

  • IPv6 static routing support for MS390 series switches

 

alemabrahao_0-1664900926777.png

 

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

That's a good sign! Although I hope it doesn't mean that it will be limited to only MS390 switches..

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels