Configure per port Vlan settings - MX Appliance

[Curtis2]

Hi,

I am attempting to configure an MX appliance as a standalone switch.  The Device has the per port vlan settings greyed out and I am unable to configure per port settings for Vlans.

[alemabrahao]

You won't be able to use MX purely in L2 if that's your intention.

For it to work you need to have the specific SVIs created.

https://documentation.meraki.com/MX/Networks_and_Routing/MX_Addressing_and_VLANs

[RaphaelL · Accepted solution]

Did you select "VLANS" and selected at least one port ?

[Curtis2]

The Per port VLAN settings is greyed out.  I'm not sure where to configure inter-vlan routing.  It seems like OSPF would be overkill.

[RaphaelL]

When you will add your appliance , you will be able to select the ports. 

Inter-vlan is enabled by default. You will need ( or not ) L3 firewall rules to allow/deny inter-vlan flows.

[Curtis2]

I went to the "add devices" section under "network-wide".  It says it was claimed.   Is there a different portion of the dashboard where I need to add the device or is this part you mentioned already done?

[alemabrahao]

For your safety, never share your device's service order number or serial number openly.

It is a good idea to open a new discussion to discuss your case or even open a support case directly with Meraki.

[alemabrahao]

Another question, is this MX new or did you buy it second hand?