I have BPDU Conflict between Dell Switch (force10) and cisco meraki ms210, as you can see in the pecture attached
I have configued the lacp port and stp. is anyone had the same issue ? could help me please ?
Fixed the image
Can you provide how you have Te0/24 on the DELL switches configured, as well as how you have the x/28 ports configured on the Meraki switches
Did you use the vlt-peer-lag port-channel command on the Dells?
This setup guide for Dell looks good. Ignore the VMWare side, and the MTU change.
Yes, I have configured trunk and vlan natative ...... on both
the VLT port lag has added already. here is the configuration on 2 dell switchs :
# interface Port-channel 100
no ip address
channel-member TenGigabitEthernet 0/24
vlt-peer-lag port-channel 100
I have tried with dynamique LACP, static LACP. unfortunately I have same erreur
Version:1.0 StartHTML:000000273 EndHTML:000016242 StartFragment:000015571 EndFragment:000016069 StartSelection:000015571 EndSelection:000016069 SourceURL:https://community.meraki.com/t5/Switching/BPDU-conflict-between-Cisco-meraki-and-Dell-Switch-force10...: BPDU conflict between Cisco meraki and Dell Switch force10 - The Meraki Community