""Binding the Network: This binds the entire network, which includes all devices in that network, to a template. This can indirectly apply switch configurations to those switches, but it’s not the same as explicitly binding each switch to a switch template. The switch will inherit network-level configurations, but switch-specific settings may not apply unless the switch is bound directly to the switch template.
Binding Switches to the Template: This directly applies only the switch-specific configurations to those switches. If switches aren't bound here, they won't receive specific configurations defined in the switch template, even if the network is bound.
When you bind a network, you're setting general configurations for the entire network. But if you want specific switch settings to take effect, you'll also need to bind the switches to the switch template directly.""
source Odd Switch Template Behavior - The Meraki Community
I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.
Please, if this post was useful, leave your kudos and mark it as solved.
