Elevator Installation?

lfischer-gcpl
Here to help

Elevator Installation?

Has anyone installed an MV security camera in an elevator?

 

If so, could you share any tips or suggestions. Thanks!

5 REPLIES 5
MRCUR
Kind of a big deal

We haven't done so yet. I think the biggest issue you might encounter is the 300' CAT6 distance limitation depending on the number of floors the elevator travels plus the distance to your nearest IDF. 

MRCUR | CMNO #12

There's a nearby IDF and the elevator is between two floors.

Hah! Neat use case. 

For one elevator I might look at mounting an AP in the top of the shaft (maybe with a panel antenna?) and using the MV12 on a wireless link...  But I'm totally thinking out loud here and I have no idea how well that would work.

MRCUR
Kind of a big deal

@lfischer-gcpl I don't think you'd have an issue with the distance limitation then. You'd need to get CAT6 run along with the power/control cables in the shaft and then you'll have CAT6 at the car to mount the camera inside. 

 

Wireless is also another good idea from @jdsilva but isn't available in MV12's firmware just yet. 

MRCUR | CMNO #12
jdsilva
Kind of a big deal

Right!  I meant to add that the wireless feature isn't slated for release till the fall. Thanks @MRCUR mentioning that!

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.