Template, Local override for NAT Traversal?

[ksumann]

Hi everyone,

i have some spoke MX, bound to a template, auto generated VLANs.

Currently one single spoke is not able to do automatic NAT traversal, so i think i need to specify a forwarding manually.

Question is: Is it possible to configure this specific device, without removing it from the template?

Greetings

[PhilipDAth]

I don't think this is possible.

[ksumann]

So i could try to set all of them to a manually set port, or i cannot use auto generated VLANs because some MX are in the template, while others are not...

Edit:

I forget that manually NAT Traversal needs an IP Adress AND port specified.

How it is supposed to work in a template? Obviously you can't have multiple different networks with same public IP and port.
It would make more sense to only specify the port while using the dhcp given public ip.

[ksumann]

Dashboard page is misleading...

You are forced to specify an IP address in the template, but its ignored afterwards, you can also use 0.0.0.0