Pre-connect Message for MFA on Cisco Secure Client

Nightstick
Here to help

Pre-connect Message for MFA on Cisco Secure Client

Hi,

I want to implement MFA with Okta verify.

I want to make a message to ask users to check the MFA soft on their phone for authentication.

I want something like this if possible :  1711iB253C17816BA13E5 (365×337) (cisco.com)

Someone now on to make it on Meraki MX with cisco secure client ? 

 

Best regards

 

4 Replies 4
CptnCrnch
Kind of a big deal
Kind of a big deal

Not exactly what you're searching for, but does Okta give something similar like this?

https://guide.duo.com/append-mode

alemabrahao
Kind of a big deal
Kind of a big deal

I don't think so, you probably need something in midfield.
 
Integrating With Cisco ISE you should be able to.
I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Maybe it will help you.

 

 

AnyConnect VPN Okta SAML Configuration - Cisco Meraki Documentation

 

Configure Cisco Meraki | Okta

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.
PhilipDAth
Kind of a big deal
Kind of a big deal

I think you are going the wrong way about this.  You should be using SAML.  Users will then see the Okta login page.

 

@alemabrahao gave some good links.

Get notified when there are additional replies to this discussion.