Possible L2 Loop Issue?

SOLVED
Happiman
Building a reputation

Possible L2 Loop Issue?

Testing Phase Three-way ConnectionTesting Phase Three-way Connection

I need to migrate a traffic path which is going through Fortinet firewall device right now.

 

Once the migration is done, Data Center network(192.168.1.0, 192.168.9.0) will pass Meraki straight without  Fortinet Fortigate firewall.


To test the migration, I am going to connect a cable between Meraki and the Core Switch and pass only a few specific routes (ex 192.168.13.0/24, 10.13.10.0/24). Other subnets will be passed by 192.168.0.0/16.

 

Once the migration is done, I will remove a cable between Meraki and Foritgate

Final Phase.jpg

 

 

 


If I connect Meraki and Core Switch  will it create a L2 loop?

1 ACCEPTED SOLUTION
PhilipDAth
Kind of a big deal
Kind of a big deal

If they are layer 3 then a loop can not happen.

View solution in original post

3 REPLIES 3
PhilipDAth
Kind of a big deal
Kind of a big deal

Are the Foritgate 192.168.2.0 and 192.168.4.0 interaces switched (aka are VLANs) or routed (aka L3 interfaces)?

 

If they are switched VLANs then yes, you may introduce a loop.

 

You have a layer 3 switch - I would avoid creating the loop and use the 4507 to control the routing.

Happiman
Building a reputation

Testing Phase.jpg

 

Ports on the Fortigate are L3 and Cisco 4507E has L2 & SVI. Since there are L3 ports between MX and Cisco Switch Loop will not happen?

 

 

PhilipDAth
Kind of a big deal
Kind of a big deal

If they are layer 3 then a loop can not happen.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels