Dear all
I configured a normal VPN, using the Hub and Spoke concept.
I configured the routes and they are published normally, however, I need to validate the LAN network connection between Meraki and FTD.
I have already configured the routing, and even so the tests are not working.
My Topology:
Site A:
ISP >> SW Operators >> FTD >> Transit between FTD x SW x Meraki.
I can connect between the transit addresses and Meraki can see them, but I have no connectivity on the LAN.
Site B:
ISP >> SW Operators >> ASA >> Transit between FTD x SW x Meraki.
Routing configured and it does not work.
I would like to validate this test with static routes and then configure BGP on Meraki and firewalls. Any tips?
IP 192.168.150.3 is the transit address of FTD Site B (Spoke);
IP 192.168.150.1 is the transit address of MX Site B (Spoke);
IP 192.168.150.2 is the transit address of SW Site B (Spoke);
IP 192.168.140.1 is the transit address of MX Site A Hub;
HUB:
Routing Table HUB:
SPOKE:
SPOKE:
Static route
No IPsec
No dynamic protocol
I can ping both Meraki, but from FTD I can't, for example, ping LAN 192.168.140.1 from site B, which is the network of site A.
Where am I going wrong?
